Good morning folks. Im in search of a serviceable crankshaft for my syncros spare engine.
The shaft i currently have has come from a 2.1 wbx engine that was dissassembled by the previous owner and has extensive pitting on all big end journals.
This in fact, could be machined out and repolished, but ive not had to confront this level of procedure before, and im also not confident in the local shops to complete such an exercise successfully, down to the correct clearances at least.
Also not sure if its a blue or a red dot for bearing sizing.
Any help here would be most appreciated.
Thanks in advance.
Rob.